







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Roofing: The Coral Gables Owner’s Guide
Unilock-compatible roof repair in Coral Gables typically runs $400 – $1,800, and a full Unilock roof replacement runs $8,000 – $20,000 installed. Whether we can get to it the same day depends on the part and the season, so call and we’ll tell you honestly where you stand. Most owners find out something failed the same way: a water stain on a ceiling near an interior wall after a summer storm, or granules and cracked pieces in the gutter run after a windy week. Coral Gables takes salt air off Biscayne Bay, a rainy season that drops most of its rain between June and October, and afternoon heat that cycles roofing materials hard. Unilock paver-profile roofing holds up well here, but the edge pieces, the fasteners, and the flashing details are what go first. When they do, the leak almost never shows up where the failed piece is. It shows up inside.
Bradford Remodeling Co Coral Gables is an independent service provider. We’re not affiliated with Unilock, and we don’t speak for them. We install and repair to the manufacturer’s specifications, and we put the price in writing before any work starts.
Which Unilock Models This Applies To

Unilock makes a range of concrete and clay paver-profile roofing and accessory pieces, and the parts aren’t interchangeable across lines. A ridge cap from one series won’t seat correctly on another, and a field tile with the wrong profile thickness will leave a lip that water pools behind. Getting this right matters more in Coral Gables than in a drier market, because standing water on a roof deck is how you get a leak inside two rainy seasons.
The reliable way to identify your part is by measurement, not memory. Pull one intact piece from a spot that isn’t leaking and measure it: the exposed face width, the overall length, and the thickness of the profile. Photograph the underside, because that’s where manufacturer stamps and lot markings usually sit, and lot markings tell us which run the original roof came from. If you have the original job paperwork or the contractor’s spec sheet, that’s faster still.
On the OEM-versus-aftermarket question: for Unilock roofing, matching the exact profile and color run matters more than matching the label. A quality aftermarket equivalent in the correct profile and thickness will perform identically and often costs less, but the color won’t match a sun-faded roof exactly. We tell owners that plainly up front rather than after the pieces arrive. Where a visible slope is involved, most Coral Gables owners choose to replace a small field of pieces rather than fight a color mismatch. On a hidden plane or a back slope, the aftermarket piece is the sensible call.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Roofing Is Failing
- Interior ceiling stains after a storm. Water is getting past a fastener, a flashing detail, or a cracked field piece. The stain is rarely under the failed part, so the fix starts with tracing the water path back up the slope, not patching the ceiling.
- Cracked or spalled pieces, especially on south and west slopes. Concrete roofing expands and contracts with the afternoon heat, and that cycling is harsher on the sun-facing planes. Spalling – where the face flakes off – is the tell that the piece has taken its thermal load.
- Loose or lifted fasteners. On a Coral Gables roof, corrosion on fasteners often starts before the roofing piece itself shows any wear. A single lifted fastener lets wind-driven rain in behind the field, and the leak shows up far from it.
- Granules in the gutters or at the downspout. Shedding granules mean the surface is breaking down. Some granule loss is normal after a hard storm; consistent shedding on every rain is not.
- Visible gaps at ridges, hips, and the wall flashing. These are the highest-stress details on any roof and the first place a Coral Gables installation fails. A gap you can see with binoculars from the yard is a gap water can find.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s the range we quote in Coral Gables, with the parts and labor in the same number. We don’t quote parts separately and markup labor at the door – the written price is the price.
| Work | Installed price range |
|---|---|
| Roof repair (single part or detail) | $400 – $1,800 |
| Unilock roof replacement (full) | $8,000 – $20,000 |
| Tile roof repair (adjacent tile work) | $600 – $2,500 |
What moves the number: how many pieces are involved, whether the leak has reached the decking or underlayment, the pitch of the roof, and how accessible the failed section is. A single cracked ridge cap on a low-slope section is at the bottom of the repair range. A failed flashing detail that has been leaking into the sheathing for two seasons is at the top, and it’s a different job. Every completed job carries the 365-Day Done Right Promise: if the work fails within a full year, we come back and correct it at no charge, and that guarantee is in writing and in your hand at close.
DIY or Call Us?
You can safely check a few things from the ground. Look up at the ridges and wall flashing with binoculars. Check the attic for staining on the underside of the deck. Note where the gutters are shedding granules. What you should not do is get up on a pitched roof in Coral Gables to pull pieces and probe fasteners. Roof work at height is where most serious homeowner injuries happen, and the repair isn’t just lifting a piece: you have to know how the underlayment and flashing will be restored or the leak comes back with the next storm. We’d rather you call, describe the symptom, and let a technician trace it. Our technicians have up to 22 years of experience, and they’re background-checked and uniformed, so you know who’s on your roof. Call (833) 510-5367 and we’ll set up a free estimate.
FAQs

A well-installed Unilock-compatible roof typically lasts 20 to 30 years in this climate, but the honest number is lower if the flashing and fasteners weren’t done correctly. Corrosion on fasteners is the part that goes first here, because of the salt air. The visible roofing pieces usually outlast the hardware holding them. Call (833) 510-5367 for an exact quote on a repair or replacement – estimates are free.
Often yes. A single cracked piece, a failed ridge cap, or a flashing detail that’s leaking can be repaired without touching the field, and that’s the right call when the surrounding roof is sound. If the fasteners across a whole slope are corroded, a spot repair just moves the problem three feet over. Call (833) 510-5367 and we’ll tell you which one you’re looking at, with a written price for either.
A single-part repair is usually a half-day to a full day, depending on access and whether the underlayment under it needs to be restored. Replacing a small field of pieces on a complicated roof can take a day or more. We give you the timeline in writing before we start, and we don’t leave the job open-ended. Call (833) 510-5367 for the estimate.
We source to the manufacturer’s specification by profile, thickness, and color run, using the measurement and lot markings off your existing piece. We work from a documented roster of name-brand materials, and Unilock is one of them – the same is true for the KraftMaid, Cambria, and Silestone products we work with elsewhere in the home. We don’t carry parts on a truck, so the part is matched to your roof rather than to whatever’s on hand. Call (833) 510-5367 to schedule your free estimate.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












