







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Roofing: The Coral Gables Owner’s Guide
Schluter doesn’t make a roofing shingle or tile. What Schluter makes is the waterproofing and drainage layer that sits underneath your roof covering – products like Schluter-KERDI and DITRA-DRAIN that handle the moisture side of a roof assembly – and in Coral Gables, that layer is the part that fails before the tile does. Replacing a failed Schluter waterproofing layer on a Coral Gables roof typically runs $8,000-$20,000 for a full roof replacement once the membrane is compromised, or $400-$1,800 for a targeted repair where the failure is isolated. We install Schluter-compatible roof assemblies across Coral Gables, and estimates are free.
Owners usually find out something is wrong the same way: a brown ring on a ceiling a few feet in from the exterior wall, a musty smell in a closet that shares a wall with the roofline, or a roofing tile that has gone loose after a rainy season. By the time a stain shows inside, the Schluter membrane underneath has been letting water through for weeks, not hours. Coral Gables gets roughly 60 inches of rain a year, most of it between June and October, so a pinhole in a drainage mat turns into a ceiling problem inside a single wet season.
Which Schluter Models This Applies To

Most Coral Gables homes running Schluter under roof tile or a low-slope roof are using one of three product families. The first is DITRA-DRAIN, a dimpled mat with a bonded fleece that lets water drain laterally under a tile bed. The second is KERDI and KERDI-BAND, the bonded waterproofing membrane and seam tape used at edges and penetrations. The third, mostly on balconies and roof terraces common in Coral Gables, is KERDI-LINE or a linear drainage profile that carries water to a scupper or drain.
Identifying which one you’re dealing with means getting a look at the substrate – pull a loose tile or look through an attic vent at the underside. The membrane is printed on its edge: the Schluter name, the product code, and a roll or lot number. That printing is the OEM-vs-aftermarket question answered. Match on product code, not on “looks similar.” The dimple depth and fleece weight on DITRA-DRAIN, not just the color, decide whether an imitation mat drains the same under Florida rain load.
Bradford Remodeling Co Coral Gables is an independent service provider and is not affiliated with Schluter. We work with Schluter systems and with the documented premium brands on our roster, including KraftMaid, Cambria, and Silestone on the interior side.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Roofing Is Failing
- Interior ceiling stains that appear after rain, not during it. That timing means water is pooling on the membrane and finding a seam hours later, which points to a failed KERDI-BAND joint, not a missing tile.
- Loose or hollow-sounding roof tiles. When the drainage mat compresses or the fleece delaminates, the tile bed loses its bond and tiles lift. In Coral Gables, we see this most on roofs over 15 years old that have gone through repeated wet-season cycling.
- Moss or algae growth on the roof surface and in the tile joints. Schluter’s dimpled drainage only works if water is moving. Growth in the joints means water is sitting, and standing water on a Coral Gables roof during the summer is a membrane problem, not a cosmetic one.
- A musty smell in an adjacent closet, garage, or soffit area. That’s moisture that has passed the membrane and started growing in the cavity. The smell usually precedes a visible stain by a full season.
- Water tracking down an interior wall during a storm. Water following a wall line is almost always a flashing or drainage termination failure where a KERDI-LINE drain or a schluter profile at a change of plane has pulled loose.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Roof replacement in Coral Gables runs $8,000-$20,000 when the Schluter layer under a tile roof has failed across a large area, and that range covers tear-off of the affected field, new Schluter membrane, new drainage mat, flashing, tile relay, and disposal. A repair where the failure is isolated to one seam or penetration runs $400-$1,800. Tile roof repair on a Schluter assembly runs $600-$2,500 where the drainage mat is intact and only the covering has moved.
What moves the number: the square footage of the failed area, whether the tile itself survives removal or has to be replaced, the number of penetrations and changes of plane that need KERDI-BAND, and the pitch of the roof, which sets the labor. We write the price before any work starts. What sits inside that written price: parts, labor, disposal, permit where required, and the 365-Day Done Right Promise. If the Schluter layer we install fails inside that year, we come back and correct it at no charge, written into the guarantee you hold.
DIY or Call Us?
What an owner can safely check: the age and product code on the membrane, visible interior staining, attic-side moisture after a rain, the condition of the tile surface, and whether water runs freely to the drains and scuppers. That’s it. What not to do: don’t walk a wet tile roof in Coral Gables, don’t pull membrane or tile to “look under it,” and don’t patch a seam with an off-the-shelf product. Roof work at height, on a wet surface, with a Schluter assembly that has to be reinstalled to spec, is a job for a trained installer – a bad patch on a Florida roof creates a leak path that shows up a season later.
If the failure is a seam or one penetration, we can repair. If the drainage mat has gone across the field, we replace. Call us at (833) 510-5367 for a free estimate and a written price. A live person answers, not a voicemail.
FAQs

14 to 22 years is the honest range in Coral Gables. UV on the tile surface and year-round humidity at the membrane side are the two things that shorten it, so a roof that sees full afternoon sun and runs a lot of wet-season rain should be inspected around year 12. Call (833) 510-5367 for an exact inspection and quote – estimates are free.
Yes, when the failure is one seam, one penetration, or one scupper, and the drainage mat across the rest of the field is intact. That’s a repair in the $400-$1,800 range. Once the mat is delaminated across a whole field, patching is money spent to come back to the same problem. Call (833) 510-5367 and we’ll tell you which one you have.
A targeted repair is a one-day job. A full replacement of a failed Schluter layer under a Coral Gables tile roof is a 3- to 6-day job, longer if the tile has to be replaced rather than reused. Weather windows do move it – nobody is tear-off-ing a roof in an afternoon thunderstorm. Call (833) 510-5367 for a schedule against your roof.
By product code and lot printed on the membrane edge, matched to the Schluter system currently on your roof. We don’t claim a warehouse or parts on a truck – what we do is specify the part by its code in the written scope, so you know exactly what goes back on and what it costs before any tool starts. Call (833) 510-5367 for a free estimate.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












