







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Driveway & Pavers: The Coral Gables Owner’s Guide
We install Mr-Glass-compatible driveway and paver systems in Coral Gables, and a full paver driveway typically lands between $7,000 and $18,000 installed, depending on square footage, base prep, and whether the old surface has to come out. Concrete runs $4,500 – $12,000, and asphalt $3,500 – $9,000. We’re an independent contractor, not affiliated with Mr-Glass.
Owners usually find the problem the same way. A paver lifts after a heavy rain and won’t sit flat again. Sand washes out from the joints in a sheet every time the afternoon storms hit. Or a hairline crack in the driveway becomes a two-inch drop at the garage apron over one wet season. Coral Gables sits on limestone and marl with a high water table, and that ground moves. When your driveway starts telling you it’s moving, you’re already behind it.
Key Takeaways
- Mr-Glass pavers and driveway systems fail from base failure and joint erosion, not from the surface material itself.
- Installed paver driveways in Coral Gables run $7,000 – $18,000; concrete $4,500 – $12,000; asphalt $3,500 – $9,000.
- Re-sealing a paver driveway costs $250 – $700 and buys you years if the base underneath is still sound.
- Our technicians have up to 22 years of experience with paver and hardscape systems.
- Every Bradford job gets a written price before work starts and the 365-Day Done Right Promise.
Which Mr-Glass Systems This Applies To

Mr-Glass builds its driveway and paver line in several thicknesses and formats, and the profile you have changes what we spec. Standard driveway pavers run 60mm; heavy-duty and commercial-rated units go to 80mm. If your driveway takes consistent vehicle weight, the 60mm is fine on a properly compacted base but the 80mm is what survives a full-size SUV turning in place in a tight Coral Gables driveway. Getting this wrong is the most common compatibility mistake we see.
To identify what you have, pull one paver at an edge or at the garage apron and measure thickness and face dimension. Check the underside for the manufacturer stamp, and note the color and finish so a replacement batch matches. Joint sand, edge restraint, and the polymeric additive are brand-specific in some Mr-Glass systems, so the restraint clips and sand matter as much as the units.
The OEM-versus-aftermarket decision: Mr-Glass replacement units are the exact match for color and dimension, which matters on a visible driveway where mismatched batches show up in sunlight. A quality aftermarket paver in the same thickness and compressive rating works fine on a full install where everything is new. On a spot repair, match the OEM batch. We work with Belgard and Unilock hardscape systems alongside Mr-Glass-compatible units, and we spec to manufacturer documentation so the material warranty holds.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Driveway & Pavers Is Failing
- Pavers lifting or rocking underfoot. That’s base failure or trapped water, not the paver. When the compacted base underneath loses its density, individual units tilt and never settle flat again.
- Joint sand washing out after storms. South Florida rain finds the low spot and strips the sand, which lets water into the base and starts the cycle. Polymeric sand on a sound base slows this; sand on a failed base doesn’t help.
- Weeds and settlement along the edge. Missing or broken edge restraint lets the field spread outward. Once the edge moves, the whole panel loses its interlock.
- Ponding or a soft, spongy spot. Coral Gables’ high water table means poor drainage shows up fast. A soft spot over a drain field or a low corner that holds water signals a base that’s saturating.
- Hairline cracks turning into a step at the apron. On concrete drives, that’s a settling slab or a failed control joint. Left alone, it grows into a trip hazard and a tripping-water problem.
Replacement Cost & What’s Included

Here’s the Coral Gables range, installed:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
The range is driven by square footage, how much old surface and base has to come out, base depth and compaction, edge restraint, drainage correction, and whether the paver field is a specialty format. We give you a written, line-item price before any work starts, with parts and labor broken out so you can see what the material actually costs against the install. No number moves at the door. The 365-Day Done Right Promise covers the finished work for a full year: if it fails inside that window, we come back and correct it at no charge. Manufacturers’ product warranties apply on top of ours.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely pull a loose paver and check thickness, measure the field, inspect the edge restraint, and read the underside stamp. That tells you what you have and whether it’s a repair or a full replacement. What you shouldn’t do yourself is reset a paver field on a failed base or pour and compact a base in Coral Gables’ water-table conditions. Base prep is the whole job here: excavation depth, gravel gradation, and compaction in lifts. Skip that and the new surface fails in one wet season. Pulling restraint clips and resetting units over a proper compacted bed is a trained-crew job with specific tools. If the base is shot, a cosmetic top-up just buys you a repeat.
Call (833) 510-5367 for a free estimate. A live person answers, day or night, and we’ll tell you whether you need a repair, a seal, or a full replacement.
FAQs

A properly installed paver driveway lasts 25 to 30 years, but the base and joint sand are what actually decide that. In Coral Gables’ rain and high water table, plan on re-sanding joints every few years and re-sealing every three to five, and the field holds up.
Often yes. A local repair that resets lifted units, restores the base under them, and replaces the edge restraint is the right call when the settlement is isolated. If the base is failing across the whole field, a spot repair won’t hold, and we’ll tell you that straight. Call (833) 510-5367 for a free estimate and a written price either way.
A typical Coral Gables paver driveway runs three to five working days, from demolition through base, pavers, and joint sand. Concrete adds cure time before you drive on it. Weather and drainage corrections move the schedule, and we tell you that up front, not the morning of.
We source to your system’s spec: thickness, face dimension, color batch, and restraint and sand type, matched against the manufacturer’s documentation. We don’t stock parts or carry them on a truck, so the material is ordered to your driveway. Every price is written before work starts, and every install carries the 365-Day Done Right Promise. We also service KraftMaid, Cambria, and Silestone lines across our remodeling work.
Contact
If your Mr-Glass driveway or pavers are moving, ponding, or losing their joints, call Bradford Remodeling Co Coral Gables at (833) 510-5367 for a free estimate. We’ll give you a written, line-item price before any work starts, put the 365-Day Done Right Promise in writing, and leave the site clean with your signed guarantee in hand. Based in Coral Gables, serving homeowners across the surrounding area, and backed by The Garrison Standard.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












