







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Blanco Home Additions & ADU: The Coral Gables Owner’s Guide
Home additions built to Blanco specifications in Coral Gables run $45,000 – $130,000 installed for an addition, and detached or attached ADUs run $90,000 – $220,000 depending on size, impact glazing, and whether the unit gets its own utility meter. That’s the honest spread on a Coral Gables lot, and a written line-item price before work begins is the only way to know where your project lands.
Homeowners usually don’t “discover” a home addition fail the way they spot a cracked tile. The signs come slower. A rear room that holds humidity after every afternoon storm. A permit file that stops mid-inspection. A framing addition from a previous owner that never got the coral rock tied back correctly. Blanco is a well-regarded cabinetry and fixture line, and it’s often specified inside additions built by other contractors. When that structure or the finishes around it start moving, the failure shows up at the cabinets, the door frames, and the seams where the original house meets the new footprint.
Key Takeaways
- Addition: $45,000 – $130,000. ADU: $90,000 – $220,000. Garage conversion: $30,000 – $80,000.
- The most common failure in Coral Gables isn’t the cabinets. It’s water intrusion at the tie-in between old and new structure.
- Every Bradford project gets a written price before work starts and the 365-Day Done Right Promise in writing at close.
Which Blanco Models This Applies To

Blanco builds cabinetry, sinks, and fixtures, and its lines vary by series. The model designation is on the inside face of a cabinet door or drawer box, usually a small label near the hinge, and on the spec sheet stapled inside the sink cabinet or under the basin. If the label is gone, measure the cabinet box depth and the door overlay pattern. Standard Blanco base cabinets run 24 inches deep with a specific overlay that tells you which series you’re matching.
Here’s the coral Gables gotcha most replacements miss: Blanco cabinet systems spec their own toe-kick height and cabinet height, and those numbers don’t always match the domestic standard other Florida builders assume. Order a replacement box or a matching cabinet without confirming the series and the new unit will sit an inch off from the run. That half-inch shows up at the countertop and the backsplash.
OEM versus aftermarket on Blanco comes down to what’s being replaced. For a full cabinet or a door face on a visible run, match the series. For internal hardware, a soft-close hinge, or a shelf clip, a quality aftermarket equivalent is a reasonable decision and often the faster one. We are an independent service provider and not affiliated with Blanco, so we source compatible parts and spec them against your actual model number rather than guessing by look.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Blanco Home Additions & ADU Is Failing
These are the symptoms Coral Gables homeowners actually call about. Each one points to a specific cause. Read them against your own project before assuming the fix is cosmetic.
- Cabinet doors that won’t stay adjusted, especially on an exterior wall. Hinges drift when the wall behind them moves. In Coral Gables that usually means moisture has gotten into the framing at the tie-in, and the door is the messenger, not the problem.
- Musty smell in the new room after summer storms. Coral Gables gets afternoon downpours that find every weak flashing detail. A musty addition means water is entering somewhere between the roof-to-wall junction and the substrate, and the cabinets are absorbing it.
- Doors and windows that bind in the addition but not in the original house. Differential movement. The new footprint is settling differently than the 1940s or 1950s structure it was tied to, and the frames are telling you exactly where.
- Cracks in the drywall at the seam where the addition meets the house. A hairline crack is normal for the first year. A crack that widens or reappears after a patch is a structural tie-in issue, and it needs a look before anyone re-finishes over it.
- Countertops separating from the cabinet run in the new room. The box has shifted or the wall it’s scribed to has moved. If your countertop is Cambria or Silestone, a separation at the wall isn’t a counter problem, it’s a backing and moisture problem.
None of these symptoms are about Blanco quality. Blancos in Coral Gables fail at the structure behind them first, and the cabinets get blamed. Diagnosing which one you have is the whole job before a dollar gets spent.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here are the honest ranges for Coral Gables, all installed. The ranges reflect real scope, real impact-rated products per Miami-Dade code, and the difference between a simple footprint and one that has to tie into coral rock.
| Project | Installed Price Range |
|---|---|
| Home addition | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
What drives the range: footprint size, whether the addition needs its own impact glazing per code, the condition of the tie-in to the original structure, and whether the scop includes the cabinetry and finish work or just the shell. A Coral Gables addition that ties into an older coral rock wall on a sloped lot sits at the top of the range. A straightforward rear addition on a flat lot sits lower.
Every price is written and line-itemed before work starts. No numbers that move at the door. Bradley pulls permits and the inspection record comes with the job, and every completed project carries the 365-Day Done Right Promise in writing. If the work fails inside that year, we come back and correct it at no charge.
DIY or Call Us?
An owner can safely check a few things without a tool in hand. Look at the label inside a cabinet door and write down the model. Measure the box depth and note the door overlay. Take photos of any crack at the addition-to-house seam and note whether it’s growing. Check whether the addition’s permit was closed with your local building department. That’s diagnosis, and it’s useful to us.
Where DIY goes wrong: any attempt to re-flash a roof-to-wall junction, re-frame a door opening that’s binding, or pull back drywall to inspect a moisture stain at the tie-in. These are the exact places where a small mistake creates a large mold problem in Coral Gables humidity. Additions are structural and code-bound, and Coral Gables building permits are part of the record that protects you at resale.
Here’s the honest line: this isn’t a part you swap. It’s a scope you define, permit, and build. Diagnosing it correctly is the free step. Call (833) 510-5367 and we’ll walk it with you.
FAQs

A properly built, code-compliant addition in Coral Gables should last decades. The framing and envelope are doing the real work. Cabinets like Blanco, if kept dry and spec’d correctly, don’t have a lifespan failure. The addition’s envelope does. The 365-Day Done Right Promise covers the first full year on our work, and the written guarantee is in your hand at close.
Often yes. A door adjustment, a re-caulk at the tie-in, or a re-flash at the roof junction is far less expensive than a full rebuild. What determines the answer is where the moisture is. If the substrate behind the cabinets is dry, a repair is the honest call. If it isn’t, a repair is a patch over a bigger problem. Call (833) 510-5367 and we’ll tell you which one you’re looking at before you commit a dollar.
A home addition typically runs several months from permit to final inspection. An ADU runs longer because it involves its own utility rough-in and separate metering. Coral Gables permitting adds time to both. We’ll give you a written scope and a realistic timeline before work starts, and we won’t hand you a start date we can’t hold.
We spec against your actual model number, drawn from the label inside the door or the original spec sheet. We work with a documented roster of name-brand materials – KraftMaid and Wellborn cabinetry, Cambria and Silestone surfaces, Kohler and Moen fixtures – so every specification is traceable and every finish has a manufacturer spec behind it. If Blanco is the right match for the room, we match Blanco. If a KraftMaid or Wellborn line serves the space better, we show you both with written pricing before anything is ordered.
Call (833) 510-5367 for your free estimate. We’ll inspect the actual failure, give you a written line-item price, and tell you plainly what the 365-Day Done Right Promise covers. A live person answers, 24 hours a day, seven days a week.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












