







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Home Additions & ADU: The Coral Gables Owner’s Guide
If your Ameristar home addition or ADU has a failing component – a leaking roof tie-in, a settling threshold, cracked stucco at the seam, or a window unit that no longer seals – we handle the repair and rebuild, and a typical scope lands in the $45,000 to $130,000 range for Coral Gables. Larger structural rework runs higher; targeted repairs on an existing addition come in at the low end. Same-day emergency response is for active water intrusion only, not for planned rebuilds.
Owners usually find the problem the same way. A dark ring appears on the ceiling under the addition, or a door in the new space stops latching as the floor heaves, or the stucco at the seam between old house and new addition shows a hairline crack that grows through the wet season. Coral Gables sits on limestone with a high water table and gets hammered by summer rain, so tie-in failures and moisture at transitions show up here sooner than in drier markets. We’re independent from Ameristar – not affiliated with the manufacturer – and we work from the actual structure in front of us, not a manufacturer’s generic spec sheet.
Key Takeaways
- Repair and rebuild scopes for Ameristar additions in Coral Gables typically run $45,000 to $130,000, with a written price before work starts.
- Moisture at the old-to-new seam is the failure we see most in Coral Gables, driven by rain and the limestone water table.
- The 365-Day Done Right Promise covers every completed project: if the work fails within a year, we return and correct it at no charge.
- A live person answers the phone 24/7. Call (833) 510-5367.
Which Ameristar Models This Applies To

Ameristar builds modular and panelized addition and ADU systems in a few product lines, and the parts that fail differ by line. Older panelized sunroom-style additions use different tie-in hardware and window units than the newer full-structure ADU packages. What matters is identifying what you actually have before ordering anything.
Start with the data plate. Ameristar systems carry an identification label, usually inside a cabinet, on an electrical panel cover, or on a structural beam near the tie-in. Photograph it. If the label is gone, measure the window rough openings and the panel dimensions – the tolerance on these systems is tighter than you’d guess, often within an eighth of an inch, and a replacement unit that’s off by a quarter inch won’t seal.
The OEM-versus-aftermarket decision is where Coral Gables owners get burned. Ameristar-branded replacement panels and window units are matched to the original system and usually the cleanest fit for a true part swap, but lead times can stretch for older lines. A quality aftermarket equivalent in the same spec – same rough opening, same thermal rating, same stucco-ready substrate – will perform as well on a repair, and often costs less. We source both and tell you which is the smarter call for your specific unit. We don’t carry parts on a truck; every part is ordered to the job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Ameristar Home Additions & ADU Is Failing
- Water staining at the seam where the addition meets the original house. The flashing at that transition has failed or was never lapped correctly. This is the number-one failure we see in Coral Gables and it gets worse every rainy season.
- A door or window that won’t latch or seal as the floor or header shifts. In Coral Gables, the limestone substrate and seasonal moisture movement cause differential settling at the addition edge. That’s a structural symptom, not a hardware problem.
- Hairline cracks in the stucco at the tie-in that widen over months. Movement between the two structures is telegraphing through the finish coat. Left alone, water gets behind the stucco and into the substrate.
- Condensation or fogging inside a window unit on the addition. The sealed glass unit has lost its seal. Common on older Ameristar lines in Florida humidity; the fix is a unit replacement, not a reseal.
- Soft spots or a spongy floor near the exterior wall. Moisture has reached the subfloor. This one needs eyes on it quickly, because the damage spreads under the finished floor before you see it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the numbers look like for Coral Gables, with the part and labor stated separately so you know exactly what you’re paying for. Every price is written before any work starts – no numbers that move at the door.
| Scope | Typical Installed Range |
|---|---|
| Full addition or ADU repair/rebuild scope | $45,000 – $130,000 |
| ADU ground-up construction (reference) | $90,000 – $220,000 |
| Garage conversion to living space (reference) | $30,000 – $80,000 |
| Impact window installation on addition (reference) | $8,000 – $25,000 |
What drives the range: the extent of structural repair at the tie-in, whether impact-rated glazing is required (Coral Gables sits in the high-velocity hurricane zone, so impact ratings matter), whether permits pull cleanly on existing work, and finish level. Parts and labor are broken out line by line. The completed work carries the 365-Day Done Right Promise – a full-year written guarantee. If it fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
You can safely check three things yourself: photograph the Ameristar data plate, note where water is staining or cracking, and test whether windows and doors latch square. That information helps us quote accurately.
What you shouldn’t do: open up the tie-in flashing, cut into stucco to inspect the substrate, or attempt to lift or level a settling addition. Addition and ADU structure is load-bearing, and a wrong move at the seam can compromise the connection between two buildings. That’s not a weekend project – it’s a structural repair, and it needs a trained professional who understands how the old house and the addition carry load together. Call (833) 510-5367 and we’ll tell you honestly whether you’re looking at a repair or a rebuild.
FAQs

Window sealed units typically fail at 15 to 20 years in South Florida humidity; flashing and tie-in details last as long as their installation and usually fail first. The wear driver in Coral Gables is moisture, not age. Call (833) 510-5367 if you’re past the 15-year mark and seeing staining – estimates are free.
Sometimes, yes – a window unit swap or a flashing rebuild is often a repair, not a full replacement. Structural settling and substrate damage usually mean a larger scope. We diagnose before we price. Call (833) 510-5367 for a free assessment.
A window unit swap is a day or two; flashing and tie-in repairs run a few days; structural rebuilds run weeks depending on scope. The written estimate states the timeline before work starts. Call (833) 510-5367 to get yours.
We match the part to your model data plate and source either the Ameristar OEM component or a quality aftermarket equivalent in the same spec, whichever is the cleaner fit. We don’t carry parts on a truck – each is ordered to the job. For finishes and surfaces we also work with documented brands including KraftMaid, Cambria, and Silestone. Call (833) 510-5367 to start.
If you’re in Coral Gables and your Ameristar addition or ADU needs a straight answer, call (833) 510-5367 for a free estimate. A live person picks up, every time. You’ll get a written price before any work starts, background-checked and uniformed technicians on the job, and the 365-Day Done Right Promise backing the finished work. Parts sourced, scope documented, site left clean, signed guarantee in your hand at close.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












