







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Home Additions & ADU: The Coral Gables Owner’s Guide
Tremron pavers and hardscape products are specified on many additions and ADUs in Coral Gables, and when the paver system around an addition fails, replacement of the affected section typically runs $45,000 – $130,000 for the full addition scope, or $90,000 – $220,000 for a full ADU build. The part-level repair that usually triggers the call – a settled patio perimeter, a cracked field paver, a failed driveway apron – is almost never a same-day swap because the substrate under it has to be corrected first. Owners usually discover the problem in the rainy season: a low corner of the addition patio ponds water, or a row of Tremron pavers along the new wall heaves and rocks underfoot.
Key Takeaways
- Most Tremron failures under a Coral Gables addition start in the base, not the paver face.
- Full addition projects run $45,000 – $130,000; ADUs run $90,000 – $220,000.
- We install Tremron-compatible hardscape as part of the addition scope, with a 365-Day Done Right Promise.
- We’re an independent remodeling contractor, not affiliated with Tremron.
Which Tremron Models This Applies To

Tremron makes several paver lines used around home additions: Olde Towne, Georgetown, Plaza, Kingston, and the newer Rangewood and Sierra lines, each sold in different nominal sizes (commonly 4×8, 6×9, 6×12, and 12×12 inches) and thicknesses (1.75-inch or 2.375-inch, with the thicker option required on driveways and vehicle aprons). Compatibility gets tricky because Coral Gables additions from the 1980s and 1990s often used Tremron profiles that have since been reformulated; a Georgetown 6×9 pulled today may not match an older run in color or chamfer depth. The way to identify what you have is to lift one paver from a hidden edge, measure length and width to the eighth inch, and photograph the underside stamp and the failing edge. We compare that against the current Tremron catalog and confirm compatibility before we set a single replacement paver.
On the OEM-versus-aftermarket question: for a structurally sound installation on a new addition, we spec the current Tremron line so the whole run matches. For a spot repair of a failing panel, the honest answer is that an aftermarket paver from another Florida manufacturer can match dimension and thickness while costing less, but it will not match color or finish. In Coral Gables, we usually recommend matching the original Tremron for repairs inside the visible field and using the closest available match only for hidden edge work. We source through the same distributors the trade uses, and we confirm the spec in writing before order.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tremron Home Additions & ADU Is Failing
The failed paver is the last stage of the problem. These are the symptoms we see most often around Coral Gables additions:
- Ponding water along the addition perimeter. That’s a settled base or a slope that no longer drains. Coral Gables’ high water table and heavy summer rain push poor drainage into a visible failure within a season.
- Heaving or rocking pavers. Usually a soil-and-sand base compacted to less than spec. Tremron’s installation guidance calls for roughly 4 inches of compacted aggregate plus 1 inch of bedding sand; a shorter base fails.
- Joint sand washing out. Failed polymeric joint sand, or sand never installed correctly, lets water into the base. Once sand erodes, pavers become loose within one wet season.
- Chipped or cracked faces on the driveway apron. Typically a thickness problem, not a bad paver. Driveway aprons need the thicker 2.375-inch Tremron profile; the 1.75-inch patio profile racks under vehicle weight.
- Settlement at the addition wall footing. Backfill that was not compacted against the new footing pulls the paver row down. This is a drainage-and-grading problem, not a paver problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Coral Gables addition, the full scope that includes reworking the Tremron hardscape runs $45,000 – $130,000. That range covers the addition structure, rough-in, finish, and the paver reset at the perimeter. A full ADU on the property runs $90,000 – $220,000. Where the failure is limited to the paver system alone, a typical paver patio installation runs $3,500 – $11,000, and a paver driveway runs $7,000 – $18,000, both installed.
What drives the range: foundation type, roof tie-in, impact glazing (Florida product approval applies in Miami-Dade County), electrical and plumbing rough-in, and how much Tremron hardscape has to be lifted and reset.
Every price we give is written before work starts. That’s the Garrison Standard. And every completed project carries the 365-Day Done Right Promise: if the work fails inside a full year, we return and correct it at no charge. The paver reset, the joint sand, and the drainage are part of that guarantee, not excluded from it.
DIY or Call Us?
You can safely check the outer edge. Lift one paver at a corner and look at the bedding: if the sand layer is under an inch, or the base material is soft, that’s your answer. Don’t try to fix a failing paver run at the addition wall yourself. The real problem is the base and the drainage; dropping a new paver on top of a failed base fails within one rainy season and can undermine the addition footing if water pools there. And when a paver failure is tied to a shifting foundation, refacing the surface masks a structural issue that gets more expensive the longer you wait.
Our technicians have up to 22 years of experience, and they’ll show you a written price on the wall before anything gets lifted. Call (833) 510-5367 to schedule your free estimate in Coral Gables.
FAQs

A properly installed Tremron paver should last 25 to 30 years. Under a Coral Gables addition, the paver itself is not the weak point; the base and drainage are. A paver on a short base with poor drainage can fail inside a single wet season.
Yes, in most cases it can. A single settled panel or a joint sand issue is a repair. We lift the pavers, re-compact the base, and re-lay them. A failed base or a drainage slope problem is a rebuild of that section. A written estimate will state which one you’re getting.
A paver panel repair typically takes one day. Rebuilding the perimeter hardscape around a full addition runs several weeks and is coordinated with the rest of the build. You get a written schedule with the price.
We order through the same distributors the trade uses, and we match the current Tremron profile to your existing run by measurement and edge profile. Where the original run is discontinued, we identify the closest current line and confirm it in writing before ordering.
If your Tremron hardscape is part of a bigger addition or ADU project, we also install KraftMaid, Cambria, and Silestone products on the interior side of the same scope.
Call Bradford Remodeling Co Coral Gables at (833) 510-5367 for your free written estimate. We’re an independent remodeling contractor; we’re not affiliated with Tremron. Every project gets a written price before work starts and the 365-Day Done Right Promise when we’re done.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












