A Bradford company - serving Coral Gables, FL
An open living room and dining area after a whole-home remodel
Jerith · Coral Gables

Jerith Fence Installation in Coral Gables, FL

Free Estimate on SiteCalls Answered by a Live Person, 24/7Background-Checked TechniciansA Local Team in Coral Gables
A remodeled living room with built-in shelves around the fireplace
A whole-home remodel with the living, dining and kitchen areas opened up
A remodeled family room with new windows and a window seat
A remodeled primary suite with built-in wardrobes and a window seat
A remodeled staircase with wood treads and a slim metal railing
New painted shaker cabinets with an organized deep drawer
A remodeled hall bathroom with patterned floor tile and painted walls
A small remodeled galley kitchen with cabinets to the ceiling
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Jerith Fence Installation: The Coral Gables Owner’s Guide

Jerith fence installation in Coral Gables typically runs $3500 – $9000 for a full residential run, and most projects are scheduled rather than rushed – we give you a written price before any work begins, so the number doesn’t move once the crew is on site. Owners usually find a failing Jerith system the same way: a post that rocks when they lean on it, a gate that drags the latch, or a picket that’s gone chalky and sharp at the edges after a few wet seasons. In Coral Gables, that’s less about age than about what the salt air, the summer rain, and the irrigation spray do to a fence over ten to fifteen years.

Call (833) 510-5367

Which Jerith Models This Applies To

A finished basement family room with a media wall and wet bar

Jerith builds ornamental aluminum fencing in a few distinct lines, and the parts don’t swap across them. The common residential series are the Classic (Traditional) line, the Majestic line with its heavier pickets and thicker rails, and the newer Grand Harbor and Wakefield profiles, each with its own rail spacing, post cap pattern and bracket geometry. A 1-1/4″ Classic picket won’t fit a Majestic rail channel and a Grand Harbor post cap won’t seat on a Traditional post, which matters when a homeowner brings us a photo and a guess.

To identify what you actually have, measure the picket width at the face (not at the swaged tip), the rail height (usually 1″ to 1-5/8″), and the post outside dimension (typically 2″, 2-1/2″ or 3″). Look for the stamped manufacturer foil label on the inside of the top rail, which lists the series. For Jerith specifically, the OEM-vs-aftermarket decision cuts both ways: genuine Jerith parts guarantee a color and profile match, but a reputable aftermarket aluminum picket and bracket set from a spec-matched supplier often holds up just as well on Florida’s coast and can shorten lead time. We’re an independent service provider, not affiliated with Jerith, and we’ll tell you honestly which route makes more sense for your run.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Jerith Fence Installation Is Failing

Most Coral Gables fence failures show up in the hardware and the ground, not the aluminum itself. Here’s what to look for:

  • Posts that rock or lean. The concrete footing has cracked or the post has lifted out of its sleeve. In Coral Gables, saltwater intrusion into the footing and heavy summer rain both accelerate this. A rocking post loads the rail brackets and will eventually pull pickets loose.
  • A gate that sags and drags the latch. The hinge plate has loosened or the gate post has shifted. Once a gate is out of square, every hinge and latch takes extra load every time you open it, and the sag gets worse fast.
  • Chalky, dull or peeling powder coat. UV exposure and salt air break down the factory finish on older Jerith runs. Once it’s chalky, the bare aluminum underneath starts to oxidize and the fence looks twice its age.
  • Rattling or loose rails and pickets. The self-tapping screws or press-fit brackets have stripped. This is common at picket tips and rail ends on older systems, and it’s a sign the fence is two hard storms from a real problem.
  • Rust streaks at the welds or footings. Usually a sign of a lower-grade bracket or fastener, not the aluminum. The original install may have used hardware that wasn’t rated for Florida’s coastal air, and it’s a cheap fix before it spreads.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

A freestanding soaking tub in a remodeled primary bathroom

For Coral Gables, Jerith fence installation costs $3500 – $9000 installed. That range covers the fence material, post setting in concrete, hardware, and labor. The low end is a relatively short straight residential run in standard black or bronze; the high end reflects a longer run, a custom gate, a corner-heavy layout, or a premium finish. Where you land in that window depends mostly on footage, post count, gate complexity, and whether we’re replacing a footing.

Here’s what the written price includes, line by line:

Line item What it covers
Fence panels Matched to your Jerith series and finish
Posts and footings Concrete-set, square-to-line
Hardware and brackets Spec-rated for coastal humidity
Gate and latch Square and adjusted before close-out
Labor and clean site Old fence hauled off, site left clean

Every completed project carries the 365-Day Done Right Promise – if the work fails inside that window, we come back and correct it at no charge. You’ll have the signed written guarantee in your hand at job close, along with a documented scope. We also handle kitchen, bath and full-home projects for neighbors with KraftMaid, Cambria and Silestone specs, but a Jerith fence is a different crew and a different scope.We’ve done both, and we price both the same way.

DIY or Call Us?

Some checks are safe for a homeowner. You can measure your pickets and rails, photograph the manufacturer foil label, check for rocking posts by hand, and test whether a latch is loose or the gate is truly out of square. That gives us a fast, accurate read on your Jerith series and lets us quote without a second trip.

Where DIY goes wrong: digging and resetting a post footing and re-striking a whole run of fence, or replacing a welded gate assembly. Getting a footing set short, or a run out of square, means the whole fence fights you later – and re-setting a post on a mature run often means digging near irrigation lines and the property line, which is where Coral Gables permits come in. If you’re replacing a fence on the lot line, we pull the permit and pass the inspection. The honest split: measure and inspect yourself, and let us handle setting, squaring and the close-out. Call (833) 510-5367 and we’ll walk your footage with you on the phone.

FAQs

A second-story addition that matches the existing roofline

How long does a Jerith aluminum fence last in Coral Gables?

A well-installed Jerith aluminum fence typically lasts 20 to 30 years, and the powder finish is usually what ages first. In Coral Gables, salt air and UV cut that timeline at the finish, not the aluminum – expect to see chalking or color fade in ten to fifteen years. Call (833) 510-5367 for a free assessment if you’re not sure whether your run has years left.

Can a failing Jerith fence be repaired instead of replaced?

Often it can, especially when the aluminum is sound and the trouble is a footing, hinge or bracket. A single failed post, a sagging gate or a stripped bracket is a repair, not a replacement. If the finish is shot and the posts are failing together, replacement usually costs less over time. We give you the repair-vs-replace number in writing so you can compare – free estimate, call (833) 510-5367.

How long does a Jerith fence swap or repair take?

A single-post or gate repair is a matter of hours; a full residential replacement usually runs two to four days depending on footage and gate count. We give you the schedule in the written price, not a vague promise at the door. Call (833) 510-5367 and we’ll size it for your property.

How do you source the right Jerith part?

We identify your series from the stamped foil label and your measurements, then source the matched part – genuine Jerith where the profile and color must match, or a spec-matched aftermarket aluminum part where it doesn’t change the performance. You’ll see the part, the spec and the price in writing before anything is ordered. Call (833) 510-5367 with your measurements and we’ll start the match.

Budgeting a fence in Coral Gables this season? Call (833) 510-5367 for a free estimate – we’ll give you a written price, a clear scope, and the 365-Day Done Right Promise on the finished work. A live person answers, 24/7, and every technician who shows up is background-checked and uniformed, so you know who’s walking through your gate. We’re part of the Garrison Partners family, held to The Garrison Standard, and we’ve squared away fence, kitchen and whole-home work the same way since 2004.

Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.

Ideas for every room in the house

Built-ins, window seats, family rooms and staircases: the changes that make a whole house work better.

Read our remodeling guides
A garage converted into a guest room and home officeA remodeled kitchen with a waterfall island and wood cabinetsA wood double vanity with two mirrors after a bathroom remodelA finished backyard cottage with a small covered porchA remodeled primary bathroom with a soaking tub and walk-in showerA single-story rear room addition with tall windows and a new patio

Explore more remodels

Every project below starts the same way: a free on-site visit and a written price.

Getting started with Bradford in Coral Gables

Every project starts with a conversation and a written price. Here is how to take the first step.

A project lead measuring a kitchen with the homeowner during a free estimate

Free on-site estimate

A project lead walks the job with you, measures it and hands you a written, line-item price. No obligation.

Book an estimate
A remodeling crew arriving at a home with lumber and tools

Your Coral Gables team

A local vetted partner works across Coral Gables and the towns around it, to the same written standard as every Bradford job.

Areas we serve
A worker laying floor protection and a dust barrier before work starts

Read our written promise

What we promise on every job, written down, with the terms spelled out before any work starts.

Our promise
Need Construction help nationwide? Licensed & insured · free written estimates
Call (833) 510-5367
Local Service Coverage

Request a Free Estimate in Coral Gables

Tell us what you need - Bradford Remodeling Co Coral Gables responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch