







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Fence Installation: The Coral Gables Owner’s Guide
We install Mr-Glass-compatible fence systems in Coral Gables, with typical installed pricing from $3,500 to $9,000 depending on run length, panel spec and gate count. Scheduled work is booked by appointment, and quotes are confirmed in writing before anything starts. Most owners here don’t discover the problem under pleasant circumstances. They find it after a wind event rattles the run, or a gate sags and stops latching, and the panel they assumed was one solid piece turns out to have a proprietary anchor they can’t match at a big-box store. That’s the moment the phone rings in Coral Gables.
Which Mr-Glass Models This Applies To

Mr-Glass markets its fencing and glass systems in several series lines, and the anchor hardware, cap profile and frame dimensions are not interchangeable between them. The most reliable way to identify what you have is the factory label on the post cap or the underside of the bottom rail. Photograph it. Then measure the actual post-to-post span in several places, not just one, because a run installed across a Coral Gables slope will read short at one end and long at the other.
The OEM versus aftermarket decision is where owners waste money. On hardware, aftermarket equivalents are usually fine and cost 30 to 50 percent less. On the glass itself, only laminated safety glass of matching thickness and edge profile survives in South Florida. Tempered glass without a laminated interlayer will shatter into pebbles in a storm, and if it’s part of your code-compliance assembly, an inspector will flag it. Match the spec sheet before you match the price. We’re an independent service provider and not affiliated with Mr-Glass, so we source by spec number, not by logo.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Fence Installation Is Failing
- Sagging gate with a slow latch. The hinge plates have loosened or the post has begun rotating in saturated soil. Coral Gables’ rainy season pushes water into the footing, and once the concrete collar cracks, the post moves and the gate follows.
- Rattling or squeaking panels in light wind. The bottom rail bushing or clip has worn past tolerance. These small nylon pieces take the daily flex load and die first, usually within a few seasons of sun cycling.
- Cloudy or whitened glass. UV degradation of the interlayer, not surface dirt. Polishing won’t fix it; the panel needs replacing. You’ll see it most on west-facing runs.
- Loose cap rails and lifted panels. A sign the post anchor has lost its grip at the footing. Wind gets under the cap, and the whole run works loose.
- Rust stain streaks at fasteners. Galvanized or coated hardware has failed and is now staining the frame and finish. Left alone, it eats into the powder coat.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Coral Gables, Mr-Glass-compatible fence installation lands at $3,500 to $9,000 installed. What moves that range is run length, panel count, gate hardware, and the footing work, which is the line most builders skip and most problems trace back to.
| Line item | Typical range |
|---|---|
| Removal and haul-off of the old run | $300 – $900 |
| Posts set in new concrete footings | $1,200 – $3,200 |
| Panels and glass per section | $150 – $450 each |
| Gate, hinges and latch | $400 – $1,100 |
| Labor | $1,000 – $2,500 |
You get a written line-item price before work starts, not an estimate that moves at the door. Every install carries the 365-Day Done Right Promise: if the work fails within a full year, we come back and correct it at no charge.
DIY or Call Us?
You can safely photograph the label, measure the span, and check gate hinges for play. That’s it. Where this goes wrong is footing depth and panel seating. A post set in shallow limestone-adjacent soil in Coral Gables will hold for one wet season and then lean, and the glass assembly is heavy enough that a two-person panel install without proper bracing risks a fall or a shattered panel. Laminated safety glass edges chip on impact, and once a panel is compromised the interlayer is done.
The honest line: read the label yourself, then let someone with experience set the footing. Call (833) 510-5367 and we’ll schedule your free estimate.
FAQs

Fifteen to twenty years for the frame and posts with proper footings, and eight to twelve years for the glass given South Florida sun load. Hardware wears first, often in five to seven years.
Yes, in most cases. Hinges, latches, bushings and clips are replaceable individually. A cracked or clouded panel has to be swapped, not repaired.
A hardware swap runs a few hours. A full panel or gate replacement is typically a one-day job, and a full run re-set runs two to three days.
By spec number and measurement, from manufacturers who publish dimensions and warranties. We’re not affiliated with Mr-Glass, and we never substitute a part that doesn’t match the panel spec.
We also carry documented brands for other rooms in the house: KraftMaid, Cambria and Silestone, among others, all with manufacturer specs behind the work.
Call (833) 510-5367 and a live person answers, day or night. We’ll confirm the spec, give you a written price before anything starts, and leave the site squared away with your signed guarantee in hand. Live-person phone coverage, background-checked technicians, and the 365-Day Done Right Promise on every completed project.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.












