







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The Coral Gables Owner’s Guide
If a section of your CWS paver driveway has settled, heaved, or started shedding joint sand, we install CWS-compatible driveway and paver systems in Coral Gables, and a full paver driveway typically runs $7,000 – $18,000 installed depending on square footage, base prep, and paver selection. Repairing a single failed run of pavers is often a smaller job, and we quote it in writing before anything gets touched. These failures almost never announce themselves all at once: homeowners usually spot them after a heavy summer storm, when one course of pavers near the garage apron has dropped below the rest.
We’re Bradford Remodeling Co Coral Gables, an independent service provider. We are not affiliated with CWS, and we don’t claim to be a CWS dealer or warranty agent, but we know the CWS product line well enough to match specs correctly and install to the standard your driveway needs. Our technicians have up to 22 years of experience, and every completed project carries the 365-Day Done Right Promise: if the work fails inside that year, we come back and correct it at no charge.
Key Takeaways
- CWS driveway and paver repairs in Coral Gables commonly run far less than a full replacement; we price both in writing.
- Most failures are base or drainage problems showing up at the surface, not defective pavers.
- Coral Gables’ sandy soil and high water table (the same conditions that flood Alhambra Circle and Granada Boulevard in a summer squall) put paver base prep under more stress than inland markets.
- Every job gets a written price before work starts and a written guarantee when it closes.
Which CWS Models This Applies To

CWS builds driveway and paver systems across several lines, and the right replacement part depends on which series you have. Before we quote anything, we look at three things: the label or stamp on the paver itself, the dimensions of the field pavers and any border course, and the condition of the base beneath. CWS pavers are typically molded in specific nominal sizes with a set thickness through the profile, and mixing thicknesses within one course (even by a few millimeters) causes lippage and rocking within a season.
The OEM versus aftermarket decision matters here. A genuine CWS replacement paver matches color, texture, and thickness exactly, but color lots drift year to year, so a single-paver repair on an older drive can look patchy even with a correct OEM part. A quality aftermarket paver from a documented brand like Belgard or Unilock is a legitimate option when we’re laying a full new field or a large section, because the manufacturer publishes specs and warranties we can hand you in writing. What we don’t do is guess at a match. We measure, we confirm the series, and we tell you plainly whether the part is still produced or whether blending a small section is the honest answer. The same discipline we apply to a CWS drive is how we handle KraftMaid, Cambria, and Silestone specifications on the interior side.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Driveway & Pavers Is Failing
Most failures trace back to the base and drainage, not the paver itself. Here’s what to watch for:
- One course sinking below the rest. Water is getting under the pavers and washing out the compacted base. In Coral Gables, the culprit is usually a low spot near a downspout or the transition to the garage apron where runoff pools.
- Rocking or “wobbling” pavers underfoot. The bedding sand layer has thinned or migrated, so the paver sits uneven. This is the point where a small repair is still cheap.
- Joint sand washing out after storms. South Florida’s summer downpours strip sand from joints faster than inland climates; bald joints let water straight into the base.
- Heaving or lifting at a corner. Usually tree roots, compaction under a driveway edge, or clay pockets in the native soil pushing pavers up as they absorb water.
- Staining or erosion along a border course. A border that’s losing its interlock lets the field pavers spread, and once that happens the whole section starts settling.
A driveway failing in the same spot twice means the base wasn’t fixed the first time. That’s the case where surface patching just delays the next fall.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed prices in Coral Gables are driven mainly by square footage, how much base has to be rebuilt, and paver selection:
| Work | Typical installed range (Coral Gables) |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
Small repairs (re-laying a settled section, re-sanding joints, re-seating a border) are quoted individually, and we give you that number in writing before work starts. What drives the range up: excavating and re-compacting badly failed base, thickness of build-up needed for Coral Gables’ sandy grade, and premium paver lines. Every completed job is covered by the 365-Day Done Right Promise, and you get the signed written guarantee at close. The site gets cleaned, the scope is documented, and nothing about the price moves at the door.
DIY or Call Us?
You can safely re-sand joints between pavers, sweep a sealed drive, and clean staining – that’s routine maintenance and worth doing. Where DIY goes wrong is the base. Pulling a settled section without addressing what’s happening underneath (drainage in a low corner, poor compaction, a washed-out sand bed) is a repeat failure waiting for the next storm season, and it can spread to the pavers beside it.
For a full re-lay, a base rebuild, or any repair that involves lifting more than a handful of pavers, call us at (833) 510-5367. We’ll tell you if a small repair is enough, and what it will cost in writing. Estimates are free.
FAQs

Quality pavers themselves can last decades, but in South Florida the base, joint sand, and sealant are what determine driveway life, and those typically need attention every few years if the driveway drains poorly. If your joints are bald and the surface is rocking, lifespan is being lost fast. Call (833) 510-5367 and we’ll inspect and quote free.
Yes, often. A single settled run, a lost border, or washed-out joints can be re-laid and re-sanded, which is far cheaper than a full replacement. A repair is not worth it if the base is failing across the whole drive. We’ll tell you honestly which you’re looking at.
Most isolated repairs (one section, re-sanding, a border fix) run a day or two, depending on how much base has to be rebuilt. A full driveway install takes longer and we schedule it in writing before work starts.
We match the paver by measuring the field and border pieces, confirming thickness through the profile, and checking the label. Genuine CWS parts are used where correct; where a year-lot color difference would show, we’ll tell you plainly and recommend either a full section or a documented equivalent like Belgard or Unilock, specs in hand.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.
Call (833) 510-5367 for a free estimate on your CWS driveway or pavers. We answer live, 24/7, and every price comes to you in writing before work begins. Part of the Garrison Partners family since 2004 and held to The Garrison Standard, we install documented brands – including Belgard and Unilock hardscape, and KraftMaid, Cambria, and Silestone indoors – so every spec is traceable and every job carries the 365-Day Done Right Promise.












