







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Silestone Home Additions & ADU: The Coral Gables Owner’s Guide
We install Silestone surfaces and the additions that house them in Coral Gables, and a home addition runs $45,000 – $130,000 installed, while a detached or attached ADU runs $90,000 – $220,000. Those are the real Coral Gables numbers, written down before we start. We’re an independent remodeling contractor, not affiliated with Silestone, so we’ll match your actual slab and cabinetry spec rather than selling you whatever’s on hand.
Owners usually call us at the failure point, not the planning point. A Silestone counter in a new addition or ADU starts telling you something’s wrong when a hairline crack opens along the sink cutout, when the seam at the island lifts, or when heat from a slow cooker leaves a dull burn ring that won’t wipe away. On the structure side, a conversion or addition shows its own symptoms: a sticking door frame means the header moved, and a fresh crack over a doorway means the slab under the new space flexed. We treat these as one job, because in Coral Gables they usually are.
Which Silestone Models This Applies To

Silestone is engineered quartz, and the part that matters on an addition or ADU project is the countertop and the substrate under it. Most failures we see in Coral Gables trace to a specific mismatch: a 2cm (three-quarter-inch) slab set over a cabinet run with too few supports, or a full-slab overhang past 10 inches with no corbel or steel angle behind it. Silestone slabs are typically sold in 56.5 x 120-inch jumbo format, so a large island in a Coral Gables ADU is often cut from one sheet, and the seam that fails is usually the one the fabricator placed near the sink for convenience, not the one the layout called for.
To identify what you’re working with, look for the sticker on the back of the remaining slab, photograph it, and measure the actual thickness with a caliper. Silestone’s naming (the standard series, the N-Boost line, the jumbo formats) doesn’t fit or price the same, and the edge profile and overhang rules change with thickness. If you’re weighing OEM-grade quartz against a cheaper imported equivalent, the honest answer for a Coral Gables addition is that quality aftermarket quartz can hold up when it’s set correctly, but the substrate and fabrication are where cheap work fails, not the slab name. We also install KraftMaid and Wellborn cabinetry under Cambria and Kohler surfaces if you’re rebuilding the run.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Silestone Home Additions & ADU Is Failing
- A crack running out from a cutout. Quartz doesn’t like unsupported edges, and a sink or cooktop cutout with too little reinforcement is the thinnest part of the slab. In Coral Gables we see this most on 2cm slabs set over old cabinets that moved after installation.
- A lifting or widened seam. The epoxy at a seam dries and shifts when the cabinet run or the floor under it settles. A smile you can feel with a fingernail means the joint is opening, not just cosmetic.
- A dull heat ring. Silestone is resin-bound quartz and won’t take a hot pan like granite. A whitened scorch mark from a slow cooker or a pan straight off the burner means resin scorched, and no polish brings it back.
- Cracks over a doorway or a new wall joint. On the addition or ADU itself, this points to slab or header movement after the build. It’s the structural counterpart to a countertop crack, and it’s why we check both before we quote.
- Water staining at the backsplash or floor edge. In Coral Gables’ humidity and afternoon storms, a poor caulk line along a counter or a shower let in moisture, and a quarter-inch of staining is where we look for the source.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For this type of job in Coral Gables, the lead range is $45,000 – $130,000 for a home addition and $90,000 – $220,000 for a full ADU. The number moves with square footage, whether the ADU is detached, and the surface spec: a countertop replacement on its own runs $2,000 – $6,500, while a garage conversion runs $30,000 – $80,000. We give you a written price before any work starts, part and labor broken out, and no number moves at the door. Every completed addition and ADU carries the 365-Day Done Right Promise: if the work fails inside that year, we come back and correct it at no charge.
What’s in the quote: the Silestone slab (or quartz equivalent), fabrication, setting, the substrate and supports, permits and inspection, and the finish. What can push the range up: a detached ADU, a structural header change, or a jumbo-slab island that needs steel reinforcement. Those are line items, not surprise invoices.
DIY or Call Us?
You can safely check your own Silestone counter: look under the sink cutout for missing supports, run a fingernail along the seam, and measure the overhang. What you shouldn’t do yourself is lift, cut, or re-set a quartz slab. Silestone is heavy (a jumbo sheet runs well north of 300 pounds), and a 2cm slab is brittle; a tipped slab cracks or injures, and a bad seam set is worse than the original. On the addition side, chasing a structural crack by patching the drywall hides the real problem and the movement returns. For the Coral Gables projects we take, our pull permits and pass inspections, and our technicians are background-checked and uniformed. Call (833) 510-5367 to schedule a free estimate, and we’ll tell you honestly whether it’s a repair or a rebuild.
FAQs

How long does a Silestone counter or a new addition last in Coral Gables? A properly supported Silestone counter runs 15 – 25 years; the slab isn’t the weak point, the substrate and supports are. A well-built addition or ADU is good for decades if it’s held to code and inspected. Our 365-Day Done Right Promise covers the work itself for a full year.
Can it be repaired instead of replaced? Often, yes. A small chip can be filled and a short crack can be stabilized if the cause is addressed. If the crack radiates from a cutout or the slab moved, a repair hides it for a while. We’ll tell you which one you’re facing before we quote.
How long does the swap take? A countertop sole replacement takes one to two days; the tear-out and setting are the slow part. An addition takes weeks, an ADU longer, and we lay out the schedule in writing before we start.
How do you source the part? We source through a documented roster of name-brand suppliers (Silestone, Cambria, Kohler, KraftMaid and Wellborn among them) so the spec and warranty trace back to the manufacturer. We don’t claim to stock parts in a warehouse or carry them on a truck; we order to your spec.
Written by the team at Bradford Remodeling Co Coral Gables, serving Coral Gables and nearby areas.
Call (833) 510-5367 for a free estimate on your Silestone addition or ADU in Coral Gables. A live person answers, and you’ll get your written price before any work starts.












