







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterHow Much Does Walk-In Shower Installation Cost in Coral Gables?
Walk-in shower installation in Coral Gables typically runs $4,500 to $12,000 for a full tear-out and rebuild, with most single-family homes landing between $6,500 and $9,500. A straightforward curbless conversion with factory tile and a standard Kohler or Moen valve sits near the low end; a fully tiled, frameless-glass build with bench, niche, and linear drain pushes toward the top. The number on your written estimate depends on the substrate behind the old walls, the tile you pick, and how much of the existing rough-in can stay.
We write that range down before a single tool comes out, and it does not move at the door. That’s The Garrison Standard: every price in writing, every guarantee in writing, backed by the 365-Day Done Right Promise.

Walk-In Shower Installation Cost Breakdown (2026)
Here’s how a Coral Gables walk-in shower build breaks out line by line. Prices reflect the local market as of 2026 and include labor and materials unless noted.
| Line Item | Typical Range |
|---|---|
| Demolition and haul-away of old shower/tub | $400 – $900 |
| Rough-in plumbing (valve, drain, supply lines) | $600 – $1,600 |
| Substrate and waterproofing (backer board, membrane, pan liner) | $700 – $1,800 |
| Shower pan / sloped mortar bed (curbless or curb) | $500 – $1,400 |
| Tile and setting materials (floor + walls) | $1,000 – $3,200 |
| Frameless or semi-frameless glass enclosure | $900 – $2,800 |
| Fixtures – Kohler or Moen valve, head, trim | $400 – $1,200 |
| Labor – tile setting, plumbing, glass install | $1,400 – $3,000 |
| Permit and inspection (Miami-Dade) | $250 – $700 |
| Total installed | $4,500 – $12,000 |
Where a project lands inside that band comes down to a handful of drivers. A true curbless design, which we build far more of in Coral Gables than in most markets, requires re-framing the floor joists and sloping the mortar bed toward a linear drain, and that structural work adds $800 to $2,000 on its own. Full-height tile on all three walls versus a tile-and-paint combo can swing $1,500. A frameless glass panel with a bench and built-in niche adds roughly $1,200 to $2,500 over a basic framed unit. When we open a wall and find a failed pan liner or termite-damaged framing, we price the repair in writing before proceeding, never as a surprise line at closeout.
What Affects Walk-In Shower Installation Pricing in Coral Gables
Coral Gables adds a few cost factors you won’t see a mile inland. Here’s what moves the number:
- Original 1920s – 1950s plumbing. A lot of homes in the Gables still have galvanized supply lines and cast-iron drains behind the tile. If the valve rough-in needs to be relocated or the drain line replaced, that’s a plumbing line item, not a cosmetic one. Figure on $600 to $1,600 more than a straight swap.
- Concrete block walls and hard plaster. Gables homes are typically block with a scratch-and-brown coat of plaster rather than drywall. Demo takes longer and the walls are harder to true up, so the substrate prep line runs higher than in newer construction. That’s a good thing long-term; block and a proper membrane hold up far better against our humidity than drywall ever will.
- Miami-Dade permitting and inspection. A walk-in shower that moves the drain, changes the pan, or relocates a valve is a permitted job under Miami-Dade code. Budget $250 to $700 for permit and inspection. We pull it and schedule it, because a shower that fails inspection at resale costs you more than the permit ever did.
- Salt air and constant humidity. Coral Gables sits a few miles from Biscayne Bay, and that salt-laden air attacks cheap fixtures fast. We spec solid-brass-body Kohler and Moen valves for that reason; they cost more up front and last far longer than builder-grade.
- Tile selection. A large-format porcelain runs less to set than a small mosaic with heavy grout lines. Natural stone like marble needs sealing and a more careful waterproofing build, adding $800 to $2,000.
- Curb vs. curbless. A standard curb shower is the value play. A true zero-threshold curbless design is the most-requested upgrade in this market for aging-in-place and resale, and it carries the structural cost noted above.

How to Save on Walk-In Shower Installation
There’s real money inside that range if you make a few decisions early. None of it means cutting corners on the waterproofing.
- Keep the drain where it is. Relocating a drain means moving the drain line under a sloped pan. If your existing drain can stay, you skip a plumbing line item and the associated permit complexity.
- Choose porcelain over natural stone. Porcelain tile performs better in a wet Florida bathroom anyway and costs less to set. Save $800 to $2,000 versus marble.
- Frameless glass where it counts. A fixed frameless panel with a hinged door looks clean without a full enclosure. It’s a fraction of the cost of a three-panel frameless setup.
- Bundle with a bathroom remodel. If the vanity or floor is on the list, doing it with the shower saves on demo, tear-out, and inspection visits, since a full bath in Coral Gables runs $9,000 to $28,000 and the shower can be folded into that scope.
- Get the written price upfront. Free estimates with a documented scope of work mean you can compare bids apples to apples. Call (833) 510-5367 and we’ll come out, measure, and put the number in writing.
Repair or Replace? Reading the Shower Before You Commit
Not every tired shower needs a full rebuild. A few checks tell you which side of the line you’re on:
- Soft or crumbling tile grout at the floor. That often means moisture has been getting behind the tile for a while. If the substrate is gone, patching won’t hold.
- Recurring caulk failure at the corners. Cosmetic fix, or a sign the pan liner has failed? We can tell once the wall is opened.
- Water staining on the ceiling below. That points to a leaking pan or drain, and it moves the job from cosmetic to plumbing.
- A tub you never use. If you’re an aging-in-place household or just prefer a shower, a tub-to-shower conversion at $3,500 to $10,000 may cover the same footprint for less than a full rebuild.
If your shower is cracked, leaking, or dated, a shower replacement at $3,000 to $8,500 may be the right scope. We’ll tell you which is honest after we look, not before.
What to Expect During Installation
A standard walk-in shower install runs three to five working days on site, spread across two or three visits to let waterproofing cure and thinset set. A curbless build with a relocated drain can stretch to seven or eight days. The sequence is fixed and we don’t rush it:
- Protect and demo. We cover the floor and adjacent rooms, then pull the old shower and haul it away.
- Open and inspect. We check the framing and rough-in, document anything that failed, and get your written approval before adding scope.
- Rough-in and waterproof. Plumbing valve and drain, backer board, a fluid-applied membrane and a proper sloped pan. This is the part nobody sees and the part that matters most.
- Inspection. Miami-Dade inspects the waterproofing and rough-in before tile goes up.
- Tile and glass. Set, grout, seal, then the glass enclosure templated and installed.
- Clean site and signed guarantee. We walk the job with you, leave the site clean, and hand you a signed written guarantee covering the work.
Our technicians have up to 22 years of experience, and every crew is background-checked and arrives in uniform, so you know exactly who is walking through your door. We install only from a documented roster, which for showers means Kohler and Moen valves and trim sets with manufacturer warranties behind our own.
The 365-Day Done Right Promise, in Plain Terms
Every shower we complete carries a full-year written guarantee. If the work fails inside that window (a pan that leaks, a seal that lets go, grout that cracks because the substrate was wrong) we come back and correct it at no charge. That’s not a verbal promise; it’s a document in your hand at job close, alongside the clean site and the written scope. It’s how the Bradford Remodeling approach works, and it’s the standard the whole team is held to.
For a broader view of how we handle homes across the Gables, see our Coral Gables service area page.
Comparing Walk-In Shower Bids
Three bids with three different scopes are the reason homeowners get burned. When you compare quotes, require each one to itemize the waterproofing method, the pan construction, the glass type, the fixtures by brand, and whether the permit is included. A bid that lumps everything into one number hides the difference. We bid every shower with a line-item breakdown and a written price you can hold us to. If another quote beats ours on the same scope, we want to see it, because the difference usually lives in what they left out. A small bathroom remodel at $5,000 to $12,000 is often a smarter bundle if the whole room needs work.
You can reach a live person 24 hours a day at (833) 510-5367 for a free estimate. No voicemail, no callback queue.
FAQs – Walk-In Shower Installation Cost
How much does a walk-in shower cost in Coral Gables?
A full walk-in shower installation in Coral Gables runs $4,500 to $12,000, with most homes landing around $6,500 to $9,500. Curbless designs and natural stone push toward the top; a standard curb shower with porcelain tile sits near the bottom. Call (833) 510-5367 for a free written estimate.
Is it cheaper to repair or replace a shower?
Repair is cheaper when the problem is surface-level; replace is cheaper over ten years when the pan or substrate has failed. A cosmetic repair runs a few hundred dollars; a shower replacement runs $3,000 to $8,500. If water has been getting behind the tile, patching rarely holds, and the honest call is a rebuild. Call (833) 510-5367 and we’ll tell you which you’re facing before you spend a dollar.
Can you install a walk-in shower the same day?
No. A proper walk-in shower takes three to five working days because waterproofing and thinset need to cure between steps. The alternative, a same-day prefab insert, skips that cure time and won’t hold up against Coral Gables humidity the way a tiled and waterproofed build does. Schedule a free estimate at (833) 510-5367.
Does a walk-in shower need a permit in Coral Gables?
Yes, when the drain, pan, or valve is moved or replaced, Miami-Dade code requires a permit and inspection, costing $250 to $700. A cosmetic tile-only change may not. We pull the permit and schedule the inspection as part of the written scope. Call (833) 510-5367 to talk through your project.
Does a walk-in shower add value in Coral Gables?
Yes. A walk-in shower is one of the most-requested bath features in the Coral Gables market, particularly for aging-in-place and resale, and it typically returns a meaningful share of its cost at resale. The $4,500 to $12,000 range is a smart place to invest because the finish and waterproofing you choose drive both the resale value and the lifespan. Call (833) 510-5367 for a free estimate.
Pricing reflects the Coral Gables market as of 2026. Bradford Remodeling Co Coral Gables offers free estimates – call (833) 510-5367.
What Our Customers Say
"Respectful crew. Covered the floors and swept every day."
- Jackie T."Kitchen remodel run by a veteran-owned crew. They started on the day promised, kept the site clean, and gave weekly updates. New cabinets and counters look great."
- Alan M."Straightforward people who do what they say. The crew did what the contract said and called before changing anything."
- Dianne W.












